This is a good article. Click here for more information.

Demon core

From Infogalactic: the planetary knowledge core
Jump to: navigation, search
A re-creation of the experiment involved in the 1945 incident. The sphere of plutonium is surrounded by neutron-reflecting tungsten carbide blocks.

The demon core was a 6.2-kilogram (14 lb), 89-millimetre-diameter (3.5 in) subcritical mass of plutonium that was involved in two criticality accidents. It briefly went supercritical in two separate accidents at the Los Alamos laboratory in 1945 and 1946, and resulted in the acute radiation poisoning and subsequent deaths of scientists Harry Daghlian and Louis Slotin. After these incidents the spherical plutonium core was referred to as the "demon core".

Manufacturing and early history

The demon core (like the second core used in the bombing of Nagasaki) was a solid 6.2-kilogram (14 lb) 3.5-inch-diameter (89 mm) sphere. It consisted of three parts: two plutonium-gallium hemispheres and a ring, designed to keep neutron flux from "jetting" out of the joined surface between the hemispheres during implosion. The core of the device used in the Trinity nuclear test at the Alamogordo Bombing and Gunnery Range in July did not have such a ring.[1][2]

File:Louis Slotin & Harry K. Daghlian Jr.jpg
The two physicists Harry Daghlian and Louis Slotin during the Trinity Test

The refined plutonium was shipped from the Hanford Site in Washington state to the Los Alamos Laboratory; an inventory document dated August 30 shows Los Alamos had expended "HS-1, 2, 3, 4; R-1" (the components of the Trinity and Nagasaki bombs) and had in its possession "HS-5, 6; R-2", finished and in the hands of quality control. Material for "HS-7, R-3" was in the Los Alamos metallurgy section, and would also be ready by September 5 (it is not certain whether this date allowed for the unmentioned "HS-8"'s fabrication to complete the fourth core).[3] The metallurgists used a plutonium-gallium alloy, which stabilized the δ phase allotrope of plutonium so it could be hot pressed into the desired spherical shape. As plutonium was found to corrode readily, the sphere was then coated with nickel.[4]

On August 10, Major General Leslie R. Groves, Jr., wrote to General of the Army George C. Marshall, the Chief of Staff of the United States Army, to inform him that:

<templatestyles src="Template:Blockquote/styles.css" />

The next bomb of the implosion type had been scheduled to be ready for delivery on the target on the first good weather after August 24th, 1945. We have gained 4 days in manufacture and expect to ship the final components from New Mexico on August 12th or 13th. Providing there are no unforeseen difficulties in manufacture, in transportation to the theatre or after arrival in the theatre, the bomb should be ready for delivery on the first suitable weather after August 17th or 18th.[3]

Marshall added an annotation, "It is not to be released on Japan without express authority from the President", as President Harry S. Truman was waiting to see the effects of the first two attacks.[3] On August 13, the third bomb was scheduled. It was anticipated that it would be ready by August 16 to be dropped on August 19.[3] This was pre-empted by Japan's surrender on August 15, 1945, while preparations were still being made for it to be couriered to Kirtland Field. The third core remained at Los Alamos.[5]

First incident

The core, assembled, was designed to be at "-5 cents", or 5 percent below critical mass.[6] In this state it takes but a small amount of additional criticality-enhancing factors to cause the core to become supercritical, and then prompt critical, "a transient-state of extremely rapid power increase".[7] Fortunately these factors are not common in the environment; they are circumstances like the compression of the solid metallic core – which would eventually be the method used to explode the bomb, the addition of more nuclear material or provision of an external reflector which would reflect outbound neutrons back into the core. The experiments conducted at Los Alamos leading to the two fatal accidents were designed to guarantee that the core was indeed close to the critical point by arranging such reflectors and seeing how much (or little) neutron reflection was required to approach supercriticality.[6]

On August 21, 1945, the plutonium core produced a burst of neutron radiation that led to Harry Daghlian's death. Daghlian, a physicist, made a mistake while performing neutron reflector experiments on the core. He was working alone; a security guard, Private Robert J. Hemmerly, was seated at a desk 10 to 12 feet (3 to 4 m) away.[8] The core was placed within a stack of neutron-reflective tungsten carbide bricks and the addition of each brick moved the assembly closer to criticality. While attempting to stack another brick around the assembly, Daghlian accidentally dropped it onto the core and thereby caused the core to go well into supercriticality, a self-sustaining critical chain reaction. Despite quick action in moving the brick off the assembly, Daghlian received a fatal dose of radiation. He died 25 days later from acute radiation poisoning.[9]

Name Origin Age at accident Profession Dose[8] Aftermath Reference
Haroutune "Harry" Krikor Daghlian, Jr. New London, Connecticut 24 physicist 200 rad (2.0 Gy) neutron
110 rad (1.1 Gy) gamma
Died 25 days after the accident of acute radiation syndrome, haematopoietic focus [10]
Private Robert J. Hemmerly Whitehall, Ohio 29 Special Engineering Detachment (SED) guard 8 rad (0.080 Gy) neutron
0.1 rad (0.0010 Gy) gamma
Died in 1978 (33 years after accident) of acute myelogenous leukemia at the age of 62 [10]

Second incident

A re-creation of the experiment made by Richard G. Hewlett, during which the 1946 accident occurred. The half-sphere is seen but the core inside is not. The beryllium hemisphere is held up with a screwdriver.
File:The demon core.jpg
The demon core

On May 21, 1946,[11] physicist Louis Slotin and seven other Los Alamos personnel were in a Los Alamos laboratory conducting another experiment to verify the exact point at which a subcritical mass (core) of fissile material could be made critical by the positioning of neutron reflectors. Slotin, who was leaving Los Alamos, was showing the technique to Alvin C. Graves, who would use it in a final test before the Operation Crossroads nuclear tests scheduled a month later at Bikini Atoll. It required the operator to place two half-spheres of beryllium (a neutron reflector) around the core to be tested and manually lower the top reflector over the core via a thumb hole on the top. As the reflectors were manually moved closer and farther away from each other, scintillation counters measured the relative activity from the core. Allowing them to close completely could result in the instantaneous formation of a critical mass and a lethal power excursion. Under Slotin's unapproved protocol, the only thing preventing this was the blade of a standard straight screwdriver, manipulated by the scientist's other hand. Slotin, who was given to bravado, became the local expert, performing the test on almost a dozen occasions, often in his trademark blue jeans and cowboy boots, in front of a roomful of observers. Enrico Fermi reportedly told Slotin and others they would be "dead within a year" if they continued performing it.[12]

On the day of the accident, Slotin's screwdriver slipped outward a fraction of an inch while he was lowering the top reflector, allowing the reflector to fall into place around the core. Instantly there was a flash of blue light and a wave of heat across Slotin's skin; the core had become supercritical, releasing an intense burst of neutron radiation estimated to have lasted about a half second.[6] Slotin quickly twisted his wrist, flipping the top shell to the floor. The heating of the core and shells stopped the criticality within seconds of its initiation,[13] but Slotin's reaction prevented a recurrence and ended the accident. The position of Slotin's body over the apparatus also shielded the others from much of the neutron radiation, but he received a lethal dose of 1,000 rad (10 Gy) neutron/114 rad (1.14 Gy) gamma in under a second and died nine days later from acute radiation poisoning. The nearest person to Slotin, Graves, who was watching over Slotin's shoulder and was thus partially shielded by him, received a high but non-lethal radiation dose. Graves was hospitalized for several weeks with severe radiation poisoning and developed chronic neurological and vision problems as a result of the exposure.[8] He died 20 years later of a heart attack. This heart attack may have been caused by hidden complications from radiation exposure, but its cause could also have been genetic, as his father had died from the same cause.[14][15][16]

There have been five studies done of the amount of radiation each person involved received in the accident; these are the latest, dated 1978, from a table in this reference:

Name Origin Age at accident Profession Dose[8] Aftermath
Louis Alexander Slotin Winnipeg, Manitoba, Canada 35 physicist 1,000 rad (10 Gy) neutron
114 rad (1.14 Gy) gamma
died 9 days after the accident of acute radiation syndrome, gastrointestinal focus [11]
Alvin C. Graves Austin, Texas 34 physicist 166 rad (1.66 Gy) neutron
26 rad (0.26 Gy) gamma
died in 1965 (19 years after the accident) of myocardial infarction, with aggravating "compensated myxedema and cataracts", while skiing [8]
Stanley Allan Kline Chicago, Illinois physicist died in 2001 (55 years after the accident); refused to take part in studies [8]
Marion Edward Cieslicki Mt. Lebanon, Pennsylvania 23 physicist 12 rad (0.12 Gy) neutron
4 rad (0.040 Gy) gamma
died of acute myelocytic leukemia in 1965 (19 years after the accident) [8]
Dwight Smith Young Chicago, Illinois 54 photographer 51 rad (0.51 Gy) neutron
11 rad (0.11 Gy) gamma
died of aplastic anemia and bacterial endocarditis in 1975 (29 years after the accident) [8]
Raemer Edgar Schreiber McMinnville, Oregon 36 physicist 9 rad (0.090 Gy) neutron
3 rad (0.030 Gy) gamma
died of natural causes in 1998 (52 years after the accident), at the age of 88 [8][13]
Theodore Perlman Louisiana 23 engineer 7 rad (0.070 Gy) neutron
2 rad (0.020 Gy) gamma
"alive and in good health and spirits" as of 1978 [8]
Private Patrick J. Cleary New York City 21 security guard 33 rad (0.33 Gy) neutron
9 rad (0.090 Gy) gamma
killed in combat in Korea in 1952 during the Korean War [8]

Two machinists in another part of the building were not treated: Paul Long and another, unidentified.[17]

After these incidents the core, originally known as "Rufus", was referred to as the "demon core".[3][18] Hands-on criticality experiments were stopped, and remote-control machines were designed by Schreiber, one of the survivors, to perform such experiments with all personnel at a quarter-mile distance.[13]

Operation Crossroads

The core was intended to be used in the Operation Crossroads nuclear tests, but after the criticality accident, time was needed for its radioactivity to decline. It was therefore scheduled for the third test of the series, provisionally named Charlie, but this was cancelled due to the unexpected level of radioactivity after the underwater Baker test and the inability to decontaminate the target warships. It was later melted down and the material reused in another core.[18][19]

References

  1. Lua error in package.lua at line 80: module 'strict' not found.
  2. Lua error in package.lua at line 80: module 'strict' not found. An error: the illustration caption states the Fat Man core was plated in silver; it was plated in nickel, as the silver plating on the gadget core blistered. The disk in the drawings is a gold foil gasket.
  3. 3.0 3.1 3.2 3.3 3.4 Lua error in package.lua at line 80: module 'strict' not found.
  4. Lua error in package.lua at line 80: module 'strict' not found.
  5. Lua error in package.lua at line 80: module 'strict' not found. Raemer Schreiber being interviewed by Richard Rhodes
  6. 6.0 6.1 6.2 Lua error in package.lua at line 80: module 'strict' not found.
  7. Lua error in package.lua at line 80: module 'strict' not found.
  8. 8.00 8.01 8.02 8.03 8.04 8.05 8.06 8.07 8.08 8.09 8.10 Lua error in package.lua at line 80: module 'strict' not found. Patient numbers in this document have been identified as: 1 - Daghlian, 2 - Hemmerly, 3 - Slotin, 4 - Graves, 5 - Kline, 6 - Young, 7 - Cleary, 8 - Cieleski, 9 - Schreiber, 10 - Perlman
  9. Lua error in package.lua at line 80: module 'strict' not found.
  10. 10.0 10.1 Lua error in package.lua at line 80: module 'strict' not found.
  11. 11.0 11.1 Lua error in package.lua at line 80: module 'strict' not found.
  12. Lua error in package.lua at line 80: module 'strict' not found.
  13. 13.0 13.1 13.2 Lua error in package.lua at line 80: module 'strict' not found.
  14. Lua error in package.lua at line 80: module 'strict' not found.
  15. Lua error in package.lua at line 80: module 'strict' not found.
  16. Lua error in package.lua at line 80: module 'strict' not found.
  17. Lua error in package.lua at line 80: module 'strict' not found.
  18. 18.0 18.1 Lua error in package.lua at line 80: module 'strict' not found.
  19. Lua error in package.lua at line 80: module 'strict' not found.