Chain gun

From Infogalactic: the planetary knowledge core
Jump to: navigation, search
The M242 25 mm Chain gun

A chain gun is a type of machine gun or autocannon that uses an external source of power to cycle the weapon rather than diverting energy from the cartridge, and does so via a continuous loop of chain similar to that used on a motorcycle or bicycle. "Chain gun" is a registered trademark of Alliant Techsystems Inc.[1] for a chain-powered weapon.


Reliability and controllability are the advantages of chain-driven weapons over their recoil-actuated counterparts. Recoil-actuated firearms depend upon the sometimes unreliable firing of a cartridge to power the cycle of action, whereas a chain gun uses an electric motor to drive a chain which moves in a rectangular circuit via four sprockets that apply tension to it. One link of the chain is connected to the bolt assembly, moving it back and forth to load, fire, extract, and eject cartridges.

A misfired round does not stop the functioning of the weapon, as it might with guns that use energy from a fired cartridge to load the next round; it is simply ejected.

During each full cycle of four periods, two periods (passage along the "long" sides of the rectangle) control the time that the bolt takes to drive forward and load a round into the chamber, and how quickly it extracts it. The other two periods, when the chain moves across the "short" sides of the rectangle, sideways relative to the axis of the barrel, determine how long the breech remains locked while firing, and open to allow cartridge extraction and ventilation of fumes.

The time that the chain takes to move around a complete loop of the rectangle controls the rate of fire, so varying the motor speed allows chain guns, in principle, to fire at a rate continuously variable from single rounds to the maximum safe rate imposed by the pressure drop rates in the barrel after firing a cartridge, mechanical tolerances, and other factors. For example, the 7.62mm NATO version EX-34 was advertised to offer 570 rounds per minute, and developmental work was underway for a 1,000-rounds-per-minute version. In practice, chain guns usually have two or three set firing speeds.

The chain gun operating principle is inherently reliable. An unclassified report on the EX-34 prepared by the Naval Surface Weapons Center in Dahlgren, Virginia, dated September 23, 1983, said that:

29,721 rounds of endurance tests were fired with no parts breakage and without any gun stoppages . . . It is significant that during firing of 101,343 rounds not one jam or stoppage occurred due to loss of round control in the gun or feeder mechanism . . . [this] is in our experience very unusual in any weapon of any caliber or type.


A commonly used chain gun is the M242 Bushmaster. Versions of its 25 mm action are found on ships (the Mk38) and Infantry fighting vehicles (the M2 Bradley and LAV-25) around the world. Others are the 30 mm M230 cannon, which is standard equipment on the AH-64 Apache helicopter, as well as the Bushmaster II 30 mm, and the Bushmaster III 35/50 mm Chain gun.

A 7.62×51mm NATO caliber chain gun is used on some armored vehicles as a coaxial machine gun, because of the inherently small amount of fumes from spent propellant discharged inside of the vehicle. A developmental version of this gun was named EX-34. It is in use as the L94A1 chain gun with the British Army.

Distinction from Gatling guns

A chain gun has a single barrel, while a Gatling gun/Minigun has several rotating barrels and internally do not use chains to drive the weapon. It is a common error to refer to Gatling guns as chain guns, particularly in connection with video games like Doom or Wolfenstein 3D.

See also


  • U.S. Army Field Manual 3-22.1

External links