In cryptology, a code is a method used to transform a message into an obscured form so it cannot be understood. Special information or a key is required to read the original message. The usual method is to use a codebook with a list of common phrases or words matched with a codeword. Encoded messages are sometimes termed codetext, while the original message is usually referred to as plaintext.
Terms like code and cipher are often used to refer to any form of encryption. However, there is an important distinction between codes and ciphers in technical work; it is, essentially, the scope of the transformation involved. Codes operate at the level of meaning; that is, words or phrases are converted into something else. Ciphers work at the level of individual letters, or small groups of letters, or even, in modern ciphers, with individual bits. While a code might transform "change" into "CVGDK" or "cocktail lounge", a cipher transforms elements below the semantic level, i.e., below the level of meaning. The "a" in "attack" might be converted to "Q", the first "t" to "f", the second "t" to "3", and so on. Ciphers are more convenient than codes in some situations, there being no need for a codebook, with its inherently limited number of valid messages, and the possibility of fast automatic operation on computers.
Codes were long believed to be more secure than ciphers, since (if the compiler of the codebook did a good job) there is no pattern of transformation which can be discovered, whereas ciphers use a consistent transformation, which can potentially be identified and reversed (except in the case of the one-time pad).
One- and two-part codes
Codes are defined by "codebooks" (physical or notional), which are dictionaries of codegroups listed with their corresponding plaintext. Codes originally had the codegroups assigned in 'plaintext order' for convenience of the code designed, or the encoder. For example, in a code using numeric code groups, a plaintext word starting with "a" would have a low-value group, while one starting with "z" would have a high-value group. The same codebook could be used to "encode" a plaintext message into a coded message or "codetext", and "decode" a codetext back into plaintext message.
However, such "one-part" codes had a certain predictability that made it easier for others to notice patterns and "crack" or "break" the message, revealing the plaintext, or part of it and, at the same time, gradually reconstruct the codebook. In order to make life more difficult for codebreakers, codemakers designed codes with no predictable relationship between the codegroups and the ordering of the matching plaintext. In practice, this meant that two codebooks were now required, one to find codegroups for encoding, the other to look up codegroups to find plaintext for decoding. Students of foreign languages work much the same way; for, say, a French-speaking person learning to speak English, there is need for both an English-French and a French-English dictionary. Such "two-part" codes required more effort to develop, and twice as much effort to distribute (and discard safely when replaced), but they were harder to break.
A one-time code is a prearranged word, phrase or symbol that is intended to be used only once to convey a simple message, often the signal to execute or abort some plan or confirm that it has succeeded or failed. One-time codes are often designed to be included in what would appear to be an innocent conversation. Done properly they are almost impossible to detect, though a trained analyst monitoring the communications of someone who has already aroused suspicion might be able to recognize a comment like "Aunt Bertha has gone into labor" as having an ominous meaning. Famous example of one time codes include:
- "One if by land; two if by sea" in "Paul Revere's Ride" made famous in the poem by Henry Wadsworth Longfellow
- "Climb Mount Niitaka" - the signal to Japanese planes to begin the attack on Pearl Harbor
- During World War II the British Broadcasting Corporation's overseas service frequently included "personal messages" as part of its regular broadcast schedule. The seemingly nonsensical stream of messages read out by announcers were actually one time codes intended for Special Operations Executive (SOE) agents operating behind enemy lines. An example might be "The princess wears red shoes" or "Mimi's cat is asleep under the table". Each code message was read out twice. By such means, the French Resistance were instructed to start sabotaging rail and other transport links the night before D-day.
- "Over all of Spain, the sky is clear" was a signal (broadcast on radio) to start the nationalist military revolt in Spain on July 17, 1936.
Sometimes messages are not prearranged and rely on shared knowledge hopefully known only to the recipients. An example is the telegram sent to U.S. President Harry Truman, then at the Potsdam Conference to meet with Soviet premier Joseph Stalin, informing Truman of the first successful test of an atomic bomb.
- "Operated on this morning. Diagnosis not yet complete but results seem satisfactory and already exceed expectations. Local press release necessary as interest extends great distance. Dr. Groves pleased. He returns tomorrow. I will keep you posted."
See also one-time pad, an unrelated cypher algorithm
An idiot code is a code that is created by the parties using it. This type of communication is akin to the hand signals used by armies in the field.
Example: Any sentence where 'day' and 'night' are used means 'attack'. The location mentioned in the following sentence specifies the location to be attacked.
- Plaintext: Attack X.
- Codetext: We walked day and night through the streets but couldn't find it! Tomorrow we'll head into X.
- The simplest sort [of code] and thereby impossible to break. The first ad told the person or persons concerned to carry out number seven or expect number seven or it said something about something designated as seven. This one says the same with respect to code item number ten. But the meaning of the numbers cannot be deduced through statistical analysis because the code can be changed long before a useful statistical universe can be reached. It's an idiot code... and an idiot code can never be broken if the user has the good sense not to go too often to the well.
Cryptanalysis of codes
While solving a monoalphabetic substitution cipher is easy, solving even a simple code is difficult. Decrypting a coded message is a little like trying to translate a document written in a foreign language, with the task basically amounting to building up a "dictionary" of the codegroups and the plaintext words they represent.
One fingerhold on a simple code is the fact that some words are more common than others, such as "the" or "a" in English. In telegraphic messages, the codegroup for "STOP" (i.e., end of sentence or paragraph) is usually very common. This helps define the structure of the message in terms of sentences, if not their meaning, and this is cryptanalytically useful.
Further progress can be made against a code by collecting many codetexts encrypted with the same code and then using information from other sources
- diplomatic cocktail party chat,
- the location from where a message was sent,
- where it was being sent to (i.e., traffic analysis)
- the time the message was sent,
- events occurring before and after the message was sent
- the normal habits of the people sending the coded messages
For example, a particular codegroup found almost exclusively in messages from a particular army and nowhere else might very well indicate the commander of that army. A codegroup that appears in messages preceding an attack on a particular location may very well stand for that location.
Of course, cribs can be an immediate giveaway to the definitions of codegroups. As codegroups are determined, they can gradually build up a critical mass, with more and more codegroups revealed from context and educated guesswork. One-part codes are more vulnerable to such educated guesswork than two-part codes, since if the codenumber "26839" of a one-part code is determined to stand for "bulldozer", then the lower codenumber "17598" will likely stand for a plaintext word that starts with "a" or "b". At least, for simple one part codes.
Various tricks can be used to "plant" or "sow" information into a coded message, for example by executing a raid at a particular time and location against an enemy, and then examining code messages sent after the raid. Coding errors are a particularly useful fingerhold into a code; people reliably make errors, sometimes disastrous ones. Of course, planting data and exploiting errors works against ciphers as well.
- The most obvious and, in principle at least, simplest way of cracking a code is to steal the codebook through bribery, burglary, or raiding parties — procedures sometimes glorified by the phrase "practical cryptography" — and this is a weakness for both codes and ciphers, though codebooks are generally larger and used longer than cipher keys. While a good code may be harder to break than a cipher, the need to write and distribute codebooks is seriously troublesome.
Constructing a new code is like building a new language and writing a dictionary for it; it was an especially big job before computers. If a code is compromised, the entire task must be done all over again, and that means a lot of work for both cryptographers and the code users. In practice, when codes were in widespread use, they were usually changed on a periodic basis to frustrate codebreakers, and to limit the useful life of stolen or copied codebooks.
Once codes have been created, codebook distribution is logistically clumsy, and increases chances the code will be compromised. There is a saying that "Three people can keep a secret if two of them are dead," Benjamin Franklin - Wikiquote and though it may be something of an exaggeration, a secret becomes harder to keep if it is shared among several people. Codes can be thought reasonably secure if they are only used by a few careful people, but if whole armies use the same codebook, security becomes much more difficult.
In contrast, the security of ciphers is generally dependent on protecting the cipher keys. Cipher keys can be stolen and people can betray them, but they are much easier to change and distribute.
In more recent practice, it became typical to encipher a message after first encoding it, so as to provide greater security by increasing the degree of difficulty for cryptanalysts. With a numerical code, this was commonly done with an "additive" - simply a long key number which was digit-by-digit added to the code groups, modulo 10. Unlike the codebooks, additives would be changed frequently. The famous Japanese Navy code, JN-25, was of this design, as were several of the (confusingly named) Royal Navy Cyphers used after WWI and into WWII.
One might wonder why a code would be used if it had to be enciphered to provide security. As well as providing security, a well designed code can also compress the message, and provide some degree of automatic error correction. For ciphers, the same degree of error correction has generally required use of computers.
- Friday (1982) by Robert A. Heinlein
- Radio Free Europe / Radio Liberty: "Middle East: Islamic Militants Take Jihad To The Internet" By Jeffrey Donovan, 16 June 2004.
- Kahn, David (1996). The Codebreakers : The Comprehensive History of Secret Communication from Ancient Times to the Internet. Scribner.
- Pickover, Cliff (2000). Cryptorunes: Codes and Secret Writing. Pomegranate Communications. ISBN 978-0-7649-1251-1.
- Code, its more general communications meaning
- List of coding terms
- Trench code
- Zimmermann telegram
- Code talkers