Curtiss Eagle
| Eagle | |
|---|---|
| 300px | |
| Eagle in trimotor configuration | |
| Role | Airliner |
| Manufacturer | Curtiss |
| Designer | William Gilmore |
| First flight | August 1919 |
| Number built | ca. 24 |
The Curtiss Eagle (retroactively designated the Model 19 by Curtiss some years later) was an airliner produced in small numbers in the United States shortly after World War I. The aircraft was a conventional biplane with three-bay, unstaggered wings of equal span. The fuselage was a very advanced design for its day, incorporating careful streamlining of its monocoque structure, and offering the crew as well as the passengers a fully enclosed cabin. The Eagle is sometimes named as the first American tri-motor aircraft; however Curtiss' own Model H flying boat flew with three engines for a time in 1914 before being converted back to twin-engine configuration.
Contents
Development
Curtiss had developed the Eagle in preparation for an anticipated post-war boom in civil aviation. In fact, this boom was far smaller than Curtiss had been hoping for, and practically all of the demand for passenger aircraft was met by the conversion of war-surplus military aircraft that could be purchased extremely cheaply. As such, only around 20 machines were built. The original trimotor Eagle design was followed by a single example of the Eagle II, with twin engines, and by three Eagle IIIs with only one engine. These latter aircraft were purchased by the United States Army Air Service, which used them as staff transports and converted one example into an air ambulance.
Operational history
On 28 May 1921, in one of the first major crashes in aviation history, Army Air Service Curtiss Eagle Serial Number 64243, the air ambulance, of the 1st Provisional Air Brigade,[1] crashed during a severe thunderstorm attempting to land at Morgantown, Maryland while returning to Bolling Field, District of Columbia, from Langley Field, Virginia. The pilot, 1st Lt. Stanley M. Ames, and six passengers were killed. Four of the six were Air Service officers and an enlisted man.[2] Two United States congressmen had chosen not to make the flight because of airsickness on the flight from Washington to Langley. The Army's Inspector General conducted an investigation of the crash and theorized that the aircraft stalled when it encountered an updraft at low altitude while trying to clear trees near the unfamiliar field and fell vertically, nose first, into the ground.
Variants
- Curtiss Eagle
- Three-engined passenger airliner, accommodating two pilots and eight passengers, powered by three 150-hp (112-kW) Curtiss K-6 piston engines.
- Eagle II
- Twin-engined version, powered by two 400-hp (298-kW) Curtiss C-12 engines; one built.[3]
- Eagle III
- Single-engined version, powered by a 400-hp (298-kW) Liberty L-12 engine; three built.
Operators
Specifications (Eagle I)
Data from Curtiss Aircraft 1907–1947[4]
General characteristics
- Crew: Two pilots
- Capacity: 6 passengers
- Length: 36 ft 9 in (11.20 m)
- Wingspan: 61 ft 4 in (18.69 m)
- Height: 12 ft 4 in (3.75 m)
- Wing area: 900 ft2 (83.6 m2)
- Empty weight: 5,130 lb (2,327 kg)
- Gross weight: 7,450 lb (3,379 kg)
- Powerplant: 3 × Curtiss K-6, 150 hp (112 kW) each each
Performance
- Maximum speed: 107 mph (172 km/h)
- Range: 475 miles (764 km)
- Rate of climb: 407[5] ft/min (2.1 m/s)
References
 |
Wikimedia Commons has media related to Curtiss Eagle. |
- ↑ Johnson, David E., "Fast Tanks and Heavy Bombers: Innovation in the U.S. Army, 1917–1945", Cornell University Press, Ithaca, New York, hdbk 1998, ppbk 2003, ISBN 0-8014-8847-8, page 83
- ↑ "BIG CURTISS-EAGLE FALLS; Driven to Ground Near Indian Head by Terrific Wind. EXACT CAUSE IS UNKNOWN None of Passengers and Crew Survives--Witnesses Unable to Discern the Trouble. ARCHIE MILLER IS KILLED Noted Soldier, Maurice Connolly and A.G. Batchelder Are Among the Victims" The New York Times, May 30, 1921, Monday, Page 1
- ↑ Lua error in package.lua at line 80: module 'strict' not found.
- ↑ Bowers 1979, p. 181.
- ↑ 10 minutes to 4,075 ft (1,242 m)
- Lua error in package.lua at line 80: module 'strict' not found.
- Lua error in package.lua at line 80: module 'strict' not found.
- Lua error in package.lua at line 80: module 'strict' not found.
