Dingwall Canal

From Infogalactic: the planetary knowledge core
Jump to: navigation, search
Dingwall Canal
288px
The canal in 2009
Specifications
Locks 0
Status reverted to river
History
Principal engineer Thomas Telford
Date completed 1816
Date closed 1880s
Geography
Start point Dingwall
Connects to Cromarty Firth
Dingwall Canal
River Peffery
Tulloch Street bridge
Dingwall wharf
Dingwall Castle
Railway bridge
Firing range
Footbridge
Harbour
Cromarty Firth

The Dingwall Canal was a short tidal canal running from the town of Dingwall to the Cromarty Firth in the county of Ross and Cromarty, Scotland. It was completed by 1819, to provide better access to the town, but was not a commercial success, and was abandoned in the 1880s after the arrival of the railways.

History

In 1578, John Leslie the Bishop of Ross produced a map of Scotland, which was published in Rome.[1] Dingwall was of sufficient importance to be included on the map, and when James VI awarded it a burgh charter in 1587, it mentioned cobbles and small boats. However, there was a problem caused by the deposition of alluvium from the rivers Conon and Orrin, which made access more difficult, and by 1773 the burgh was in a depressed state. There is some indication that improvements were made to the river soon afterwards, on a plan dated 1777, but a major scheme was actioned in 1815. The River Peffery was made deeper and wider, to allow boats to reach the town. The project was designed by the canal engineer Thomas Telford, and involved diverting the river through a temporary cut, so that a new course for it could be constructed. The work was completed by 1819, at a total cost of £4,365, to which the burgh had contributed £100 in 1815.[2]

The canal was not a commercial success, as it only generated an income of £100 per year. In 1828, Telford estimated that repairs were needed which would cost £800, and so the town council asked the Commissioners for Highland Roads and Bridges to take over responsibility for it. Their action was not successful, and the burgh continued to manage it. By 1838, it was deemed to be a tolerably good harbour, and there was incoming trade in coal, lime and other goods, with grain, timber and bark passing in the other direction.[2][3] Ships could dock safely away from the mud flats in what was effectively a tidal basin.

Decline

The canal was 1.1 miles (1.8 km) in length,[4] and its life was fairly short. The Inverness and Ross-shire Railway arrived in Dingwall in 1863, becoming part of the Highland Railway two years later, after which most of the traffic was lost,[5] and the canal ceased to be used by the 1880s.[4] The railway crossed the canal by a bridge which is a listed structure. Immediately to the north of the canal, the railway forks, with one line running northwards to Wick and Thurso, and the other running westwards to the Kyle of Lochalsh.[6] The harbour at the mouth of the canal and a footbridge near the harbour are also listed structures.[2]

Legacy

File:DingwallCanal2.jpg
Warning signs at the side of the canal

The route of the canal still forms a pleasant walk from the town to a picnic site on the Cromarty Firth, although there is a firing range nearby, which fires over the canal, and so there are red warning flags and signs to indicate when it is unsafe to use this route.

Dingwall has a Common Good Fund, which was set up to benefit the people of the town. The deeds for the old part of Jubilee Park, which is located on the south bank of the canal, indicate that the canal is one of the assets of that fund, although no deeds have been found to prove that this is actually the case.[7]

See also

Points of interest

Bibliography

  • Lua error in package.lua at line 80: module 'strict' not found.
  • Lua error in package.lua at line 80: module 'strict' not found.
  • Lua error in package.lua at line 80: module 'strict' not found.

References

  1. Skelton 1950, pp. 103–106
  2. 2.0 2.1 2.2 Lua error in package.lua at line 80: module 'strict' not found.
  3. Lindsay 1968, pp. 184–185
  4. 4.0 4.1 Cumberlidge 2009, p. 388
  5. Dingwall Historic Trail
  6. Lua error in package.lua at line 80: module 'strict' not found.
  7. Lua error in package.lua at line 80: module 'strict' not found.

External links