Instrument landing system glide path

From Infogalactic: the planetary knowledge core
Jump to: navigation, search
Emission patterns of the localizer and glide slope signals.
Glide slope station for runway 09R at Hannover Airport in Germany

Instrument landing system glide path (short: glide path of ILS [G/P] also glide slope of ILS [G/S]) is – according to Article 1.106 of the International Telecommunication Union´s (ITU) ITU Radio Regulations (RR)[1] – defined as « A system of vertical guidance embodied in the instrument landing system which indicates the vertical deviation of the aircraft from its optimum path of descent

Each radio station or system shall be classified by the service in which it operates permanently or temporarily.

See also
<templatestyles src="Module:Hatnote/styles.css"></templatestyles>

Principle of operation

A glide slope station uses an antenna array sited to one side of the runway touchdown zone. The GS signal is transmitted on a carrier signal using a technique similar to that for the localizer. The centre of the glide slope signal is arranged to define a glide path of approximately 3° above horizontal (ground level). The beam is 1.4° deep (0.7° below the glide-path centre and 0.7° above).

The pilot controls the aircraft so that the glide slope indicator remains centered on the display to ensure the aircraft is following the glide path to remain above obstructions and reach the runway at the proper touchdown point (i.e., it provides vertical guidance).

Carrier frequency pairings for localizer and glide slope

Two signals are transmitted on one of 40 ILS channels. One is modulated at 90 Hz, the other at 150 Hz. These are transmitted from co-located antennas. Each antenna transmits a narrow beam.

Localizer (LOC) and glide slope (G/S) carrier frequencies are paired so that the navigation radio automatically tunes the GS frequency which corresponds to the selected LOC frequency. The LOC signal is in the 110 MHz range while the G/S signal is in the 330 MHz range.[2]
LOC carrier frequencies range between 108.10 MHz and 111.95 MHz (with the 100 kHz first decimal digit always odd, so 108.10, 108.15, 108.30, etc., are LOC frequencies and are not used for any other purpose). See Instrument Landing System (ILS) Frequencies on even-numbered TACAN channels from 18X to 56Y.

References / sources

  1. ITU Radio Regulations, Section IV. Radio Stations and Systems – Article 1.106, definition: instrument landing system (ILS)
  2. Lua error in package.lua at line 80: module 'strict' not found.