JetBlue Airways Flight 292

From Infogalactic: the planetary knowledge core
(Redirected from JetBlue Flight 292)
Jump to: navigation, search
JetBlue Airways Flight 292
JetBlue292Landing.jpg
Sparks shoot out from N536JB's front wheels scraping the runway surface after the tires were torn off on touchdown.
Incident summary
Date September 21, 2005 (2005-09-21)
Summary Undercarriage malfunction
Site Los Angeles, California
Passengers 140
Crew 6
Fatalities 0
Survivors 146 (all)
Aircraft type Airbus A320-232
Aircraft name Canyon Blue
Operator JetBlue Airways
Registration N536JB
Flight origin Bob Hope Airport, Burbank, California
Destination John F. Kennedy Int'l Airport, New York City

JetBlue Airways Flight 292 was a scheduled flight from Bob Hope Airport in Burbank, California to John F. Kennedy International Airport in New York City. On September 21, 2005, Captain Scott Burke executed an emergency landing in the Airbus A320-200 at Los Angeles International Airport after the nose gear jammed in an abnormal position.[1] No one was injured.

Incident

Carrying 140 passengers and six crew, the Airbus A320-232 departed Burbank at 3:17 pm PDT (UTC-7). The aircraft, which was built in 2002,[2] bore the tail number N536JB[3] and the name "Canyon Blue". It was scheduled to fly 2,465 miles (3,967 km) to John F. Kennedy International Airport.

After takeoff from Burbank, the pilots realized that they could not retract the landing gear. They then flew low over Long Beach Municipal Airport (LGB) in Long Beach (the location of a JetBlue hub) to allow officials in the airport's control tower to assess the damage to its landing gear before attempting a landing. It was found that the nosewheel was rotated ninety degrees to the left, perpendicular to the direction of the fuselage.

Rather than land at Long Beach Airport, the pilot-in-command made the decision that the aircraft would land at Los Angeles International Airport (LAX), in order to take advantage of its long, wide runways and modern safety equipment.

The pilots flew the aircraft, which can carry up to 46,860 pounds (21,255 kg) of aviation fuel, in a figure eight pattern between Bob Hope Airport in Burbank and LAX for more than two hours in order to burn fuel and lower the risk of fire upon landing. This also served to lighten the plane, reducing potential stress on the landing gear and dramatically lowering landing speed as well.[4][5] The Airbus A320 does not have the mechanical facility to dump fuel,[6] despite various news agencies reporting that the aircraft was doing so over the ocean.

Because JetBlue planes are equipped with DirecTV satellite television, passengers on Flight 292 were able to watch live news coverage of their flight while the plane circled over the Pacific for hours. The in-flight video system was turned off "well before landing"[citation needed]. Actress Taryn Manning was on the flight on her way to New York to promote the film Hustle & Flow.[7] Screenwriter Zach Dean was also on the plane, and while contemplating his mortality resolved to write a script about mortality (which eventually became the movie Deadfall).[8]

Emergency services and fire engines were standing by on the LAX tarmac ahead of the landing. Although foam trucks were available, they were not used. The U.S. FAA no longer recommends pre-foaming runways, chiefly due to concerns that it would deplete firefighting foam supplies which might later be needed to respond to a fire; it is also difficult to determine exactly where a runway should be foamed, and pre-foaming might also reduce the effectiveness of the aircraft's brakes, potentially causing it to slide off the runway.[9]

Los Angeles Fire Dept. Battalion Chief Lou Roupoli said, "The pilot did an outstanding job. He kept the plane on its rear tires as long as he could before he brought [the nose gear down]."[10] When the nose gear did touch down, there were sparks and flames from it, but no apparent damage to the rest of the plane. At 6:20pm PDT (UTC-7), the aircraft came to a stop very close to the end of the 11,096-foot (3382-meter) runway 25L. In an attempt to keep the nose gear off the ground as long as possible, reverse thrust was not used to slow the aircraft. The pilots therefore used a much larger portion of the available runway than in a typical landing, stopping 1,000 feet / 305 m before the end of the runway, validating the decision to divert from Long Beach, where the longest runway is 10,000 feet (3048 m).[11]

Aftermath and evaluation

Passengers began to disembark less than seven minutes later. The landing was smooth and no physical injuries were reported. The aircraft was evacuated via airstairs, as opposed to Evacuation Slides typically used in an emergency situation.

As JetBlue did not operate from LAX at the time, the aircraft was towed to a Continental Airlines hangar at LAX for evaluation.[12]

Expert opinion expressed was that, despite the drama and live worldwide coverage, there was little real danger to the passengers or crew of Flight 292.[13] The A320, like all modern airliners, is engineered to tolerate certain failures, and, if necessary, can be landed without the nose gear at all.[13]

A similar incident with an A320 occurred on an America West Airlines flight in February 1999 in Columbus, Ohio (Flight 2811).[14] The National Transportation Safety Board (NTSB) found the cause was a failure of the external o-rings in the nose landing gear steering module.[5] That plane also landed safely.

The media reported that this was at least the seventh occurrence of an Airbus A320 series aircraft touching down with the landing gear locked ninety degrees out of position, and one of at least sixty-seven "nose wheel failures" on A319, A320 and A321 aircraft worldwide since 1989. Earlier incidents included another JetBlue flight bound for New York City, a United Airlines flight into Chicago, and an America West flight into Columbus, Ohio. While some incidents were traced to faulty maintenance and denied as a design flaw by Airbus Industries, the manufacturer had issued maintenance advisories to A320 owners which were later mandated as Airworthiness Directives by American and French aviation authorities.[15] Messier-Dowty, which manufactures nose gear assemblies for the A320, stated in an NTSB report in 2004 that part of the gear had been redesigned to prevent future problems, but at the time the redesign was awaiting approval.[16] Mechanics familiar with this common fault usually replace or re-program the Brake Steering Control Unit (BSCU) computer.

The NTSB report says that worn-out seals were to blame for the malfunction, and that the BSCU system contributed to the problem. The NTSB reported that Airbus had since upgraded the system to take care of the problem.[17]

Following the incident, the aircraft was repaired and returned to service still bearing the name "Canyon Blue." The flight route designation for JetBlue's flights from Burbank to New York was changed from 292 to 358 (the other direction became 350).

References

  1. "NERVES OF STEEL: JetBlue pilot's a poised pro," New York Daily News, September 23, 2005
  2. 7 Airbus Jets Had Landing Gear Trouble
  3. Lua error in package.lua at line 80: module 'strict' not found.
  4. Lua error in package.lua at line 80: module 'strict' not found.
  5. 5.0 5.1 Emergency landing televised on flight - Life - MSNBC.com
  6. Lua error in package.lua at line 80: module 'strict' not found.
  7. http://www.today.com/id/9444104/ns/today-today_entertainment/t/taryn-manning-recalls-jetblue-scare/#.VR1NmJPF9ew
  8. Lua error in package.lua at line 80: module 'strict' not found.
  9. Lua error in package.lua at line 80: module 'strict' not found.
  10. Lua error in package.lua at line 80: module 'strict' not found.
  11. http://www.gcr1.com/5010web/airport.cfm?Site=LGB&AptSecNum=3&SpecRWYid=1580012
  12. Lua error in package.lua at line 80: module 'strict' not found.
  13. 13.0 13.1 Great Video, But Little Danger in Emergency Jet Landing
  14. NYC99IA062
  15. NYC99IA062
  16. Lua error in package.lua at line 80: module 'strict' not found.
  17. Worn-out seals blamed in 2005 JetBlue landing

External links

Lua error in package.lua at line 80: module 'strict' not found.