Burst noise

From Infogalactic: the planetary knowledge core
(Redirected from Random telegraph signal)
Jump to: navigation, search
File:Popcorn noise graph.png
Graph of burst noise

Burst noise is a type of electronic noise that occurs in semiconductors. It is also called popcorn noise, impulse noise, bi-stable noise, or random telegraph signal (RTS) noise.

It consists of sudden step-like transitions between two or more discrete voltage or current levels, as high as several hundred microvolts, at random and unpredictable times. Each shift in offset voltage or current often lasts from several milliseconds to seconds, and sounds like popcorn popping if hooked up to an audio speaker.[1]

Popcorn noise was first observed in early point contact diodes, then re-discovered during the commercialization of one of the first semiconductor op-amps; the 709.[2] No single source of popcorn noise is theorized to explain all occurrences, however the most commonly invoked cause is the random trapping and release of charge carriers at thin film interfaces or at defect sites in bulk semiconductor crystal. In cases where these charges have a significant impact on transistor performance (such as under an MOS gate or in a bipolar base region), the output signal can be substantial. These defects can be caused by manufacturing processes, such as heavy ion implantation, or by unintentional side-effects such as surface contamination.[3][4]

Individual op-amps can be screened for popcorn noise with peak detector circuits, to minimize the amount of noise in a specific application.[5]

See also

References

  1. Random Telegraph Signal — Review of Noise in Semiconductor Devices and Modeling of Noise in Surrounding Gate MOSFET, Bipin Rajendran
  2. Operational Amplifier Noise PredictionIntersil Application Note
  3. Noise Analysis In Operational Amplifier CircuitsTexas Instruments application report
  4. Noise Sources in Bulk CMOS — Kent H. Lundberg
  5. Op-Amp Noise can be Deafening Too "Today, although popcorn noise can still occasionally occur during manufacturing, the phenomenon is sufficiently well understood that affected devices are detected and scrapped during test."

External links