Tumut Hydroelectric Power Station

For other uses, see Tumut (disambiguation).

Tumut 1 Power Station
An aerial photo of Tumut Pondage and dam, 2009.
Location of Tumut 1 Power Station in Australia New South Wales
Coordinates
Status	Operational
Opening date	1959
Owner(s)	Snowy Hydro
Reservoir
Creates	Tumut Pond Reservoir
Total capacity	52,793 ML (1,864.4×10^6 cu ft)
Catchment area	332 km2 (128 sq mi)
Surface area	202.7 ha (501 acres)
Power station
Operator(s)	Snowy Hydro
Commission date	1959
Type	Conventional
Hydraulic head	292.6 m (960 ft)
Turbines	4
Installed capacity	330 MW (440,000 hp)
Annual generation	847 GWh (3,050 TJ)
280px Service entrance to the Tumut 2 Power Station
Official name	Tumut 2 Hydroelectric Power Station
Location	Snowy Mountains Scheme, New South Wales
Status	Operational
Commission date	Tumut 2: 1962
Owner(s)	Snowy Hydro Limited
Power generation
Units operational	Tumut 2: 4
Nameplate capacity	Tumut 2: 286.4 MW (384,100 hp)
280px Tumut 3 Power Station
Official name	Tumut Hydroelectric Power Station 3
Coordinates
Status	Operational
Commission date	1973
Pumped-storage power station
Upper reservoir	Talbingo Reservoir
Upper res. capacity	921,400 ML (32,540×10^6 cu ft)
Hydraulic head	150.9 m (495 ft)
Pump-generators	6
Power generation
Make and model	Tokyo Shibaura Electric
Nameplate capacity	1,500 MW (2,000,000 hp)
Website Tumut 3 Power Station at www.snowyhydro.com.au

Tumut Hydroelectric Power Station /ˈtjuːmət/ is a series of three hydroelectric power stations on the Tumut River in New South Wales, Australia, that are part of the Snowy Mountains Scheme.

The generating assets of the three Tumut power stations are owned by Snowy Hydro Limited, a company whose shareholders include the governments of Australia, New South Wales, and Victoria. The company is also licensed to manage the water rights used by the power stations.

Stations

Tumut 1 Power Station

Located downstream of Tumut Pond Dam and 366 metres (1,201 ft) below ground level, Tumut 1 Power Station is situated approximately 3 kilometres (1.9 mi) south-east of Cabramurra. The conventional hydroelectric power station has four turbine generators, with a generating capacity of 330 megawatts (440,000 hp) of electricity; and a net generation of 847 gigawatt-hours (3,050 TJ) per annum. The power station was completed in 1959, and has 292.6 metres (960 ft) rated head.

The first 330 kV transmission lines were commissioned in New South Wales at the Tumut 1 Power Station during the 1950s. These cables were manufactured in England and linked to the underground transformers at Tumut 1, and connected with the transmission line. The lines carried power to Sydney where new sub-stations were established, to handle the upgrade from 132 kV transmission lines. This innovative plan, which faced significant scepticism initially, was considered to be at the forefront of technology which challenged designers and overseas manufacturers. Extra high voltage was in its infancy in the early 1950s. The lines were subject to a 1000 kV test on the cables prior to them going into service. These cables and the transmission system have been in service for over 50 years.

The original transformer at Tumut 1 weighed 81.2 tonnes (89.5 short tons); and each assembled generator rotor is in excess of 203 tonnes (224 short tons) necessitating delivery in component pieces and assembly on site.

Upper Tumut Power Station is sometimes used as a collective term to refer to both Tumut 1 and Tumut 2 Power Stations.

Tumut 2 Power Station

Tumut 2 Power Station is located near Cabramurra, some 244 metres (801 ft) below ground level. The conventional hydroelectric power station has four Francis turbine generators, with a combined generating capacity of 286.4 megawatts (384,100 hp) and a net generation of 787 gigawatt-hours (2,830 TJ) per annum. The power station was completed in 1962, and has 262.1 metres (860 ft) rated head. Water flows through the turbines at the rate of 118.9 cubic metres per second (4,200 cu ft/s).

The conventional gravity-fed hydroelectric power station is fed by water held in Tumut Two Pondage and from water discharged from Tumut 1 Power Station. The station is connected to the National Electricity Market via the Cabramurra substation.

Tumut 3 Power Station

Tumut 3 Power Station is the first pumped storage hydroelectric power station in Australia. Pump-storage schemes use off-peak energy to pump water to a reservoir on a higher level. This water then passes through turbines to generate electricity when prices are higher. The sole powerhouse is located above ground, approximately 1,800 metres (5,900 ft) below Talbingo Dam.

The power station is fitted with six Toshiba turbines, each equipped with Melco-manufactured generators, has a combined generating capacity of 1,500 megawatts (2,000,000 hp) of electricity. The power station was completed in 1973, and has 150.9 metres (495 ft) rated head. Water is pumped through six pipelines, each 488 metres (1,601 ft) long and 5.6 metres (18 ft) in diameter, delivering water to Talbingo Reservoir.

During 2003, Snowy Hydro commissioned six 140 kilowatts (190 hp) micro-hydro generators on the existing cooling water systems on each of the six generating units at Tumut 3 Power Station. These GreenPower accredited units enable Snowy Hydro to save approximately 3,137 tonnes (3,458 short tons) of carbon dioxide per annum. In addition, this installation not only captures previous wasted renewable energy, but also will be substantially reducing the noise that was associated with the previous pressure reducing valves on the six generating unit's cooling systems. Between 2009 and December 2011, there was a major upgrade of Tumut 3, adding additional capacity in the range of 25 megawatts (34,000 hp) to 50 megawatts (67,000 hp) per unit.

See also

• List of power stations in New South Wales
• List of dams and reservoirs in New South Wales