South African Class 15C 4-8-2

South African Class 15C (15CB) 4-8-2

300px Class 15C Big Bill, as delivered, c. 1925

Type and origin ♠ With 57 inch (1,448 mm) coupled wheels ♥ With 60 inch (1,524 mm) coupled wheels ♣ Copper firebox - ♦ Steel firebox - ʘ Reboilered ʘ 23x28 Cylinders - ʘ 24x28 Cylinders Power type Steam Designer Baldwin Locomotive Works Builder Baldwin Locomotive Works Serial number 58307, 58308, 58708-58717 Model Class 15C Build date 1925-1926 Total produced 12

Specifications Configuration 4-8-2 (Mountain) Driver axle 2nd coupled axle Gauge 3 ft 6 in (1,067 mm) Cape gauge Leading dia 30 in (762 mm) Coupled dia ♠ 57 in (1,448 mm) ♥ 60 in (1,524 mm) Trailing dia 33 in (838 mm) Tender wheels 34 in (864 mm) Wheelbase  • Engine 35 ft 8 in (10,871 mm)  • Leading 6 ft 10 in (2,083 mm)  • Coupled 15 ft 9 in (4,801 mm)  • Tender 20 ft 5 in (6,223 mm)  • Tender bogie 6 ft 2 in (1,880 mm) Length:  • Over couplers Height ♠ 12 ft 10 in (3,912 mm) ♥ Frame type Bar Axle load ♠♣ ♠♦ ♥♣ ♥♦  • Leading ♠♣ ♠♦ ♥♣ ♥♦  • 1st coupled ♠♣ ♠♦ ♥♣ ♥♦  • 2nd coupled ♠♣ ♠♦ ♥♣ ♥♦  • 3rd coupled ♠♣ ♠♦ ♥♣ ♥♦  • 4th coupled ♠♣ ♠♦ ♥♣ ♥♦  • Trailing ♠♣ ♠♦ ♥♣ ♥♦  • Tender bogie Bogie 1: Bogie 2:  • Tender axle Adhesive weight ♠♣ ♠♦ ♥♣ ♥♦ Loco weight ♠♣ ♠♦ ♥♣ ♥♦ Tender weight Loco & tender weight ♠♣ ♠♦ ♥♣ ♥♦ Tender type KT (2-axle bogies) Fuel type Coal Fuel capacity 14 LT (14.2 t) Water cap Boiler:  • Pitch ♠ 8 ft 6 in (2,591 mm) ♥  • Diameter  • Tube plates  • Small tubes ♠ 143: ʘ 117:  • large tubes ♠ 30: ʘ 34:  • Firebox type Round-top, combustion chamber Boiler pressure ♠ 200 psi (1,379 kPa) ♥ 210 psi (1,448 kPa) Safety valve Coale Pop Firegrate area 48 sq ft (4.5 m2) Heating surface ♠ 2,777 sq ft (258.0 m2) ʘ 2,584 sq ft (240.1 m2)  • Tubes ♠ 2,554 sq ft (237.3 m2) ʘ 2,361 sq ft (219.3 m2)  • Firebox 200 sq ft (19 m2) Superheater Schmidt  • Heating area ♠ 716 sq ft (66.5 m2) ʘ 670 sq ft (62 m2) Cylinders Two Cylinder size ʘ 23 in (584 mm) bore ʘ 24 in (610 mm) bore ʘʘ 28 in (711 mm) stroke Valve gear Walschaerts Valve type Piston Couplers Bell link-and-pin AAR knuckle (c. 1930s-1950s)

Performance figures Power output ♠ʘ 38,980 lbf (173.4 kN) @ 75% ♠ʘ 42,440 lbf (188.8 kN) @ 75% ♥ʘ 38,880 lbf (172.9 kN) @ 75% ♥ʘ 42,340 lbf (188.3 kN) @ 75%

Career Operators South African Railways Class Class 15C, 15CB Number in class 12 Numbers 2060–2071 Nicknames Big Bill Delivered 1925-1926 First run 1925 Withdrawn 1976

♠ The leading coupled axle had flangeless wheels

The South African Railways Class 15C 4-8-2 of 1925 was a steam locomotive.

In 1925, the South African Railways placed two American-built Class 15C steam locomotives with a 4-8-2 Mountain type wheel arrangement in service. Another ten locomotives were ordered and delivered a year later. In 1926, these locomotives were reclassified to Class 15CB.

Manufacturer

On 15 December 1924, after an official tour of investigation to the United States of America by G.E. Titren, the Superintendent Motive Power of the South African Railways (SAR), an order was placed with the Baldwin Locomotive Works (BLW) of Philadelphia for four experimental locomotives, two of which were of a 4-8-2 Mountain type wheel arrangement. These locomotives, both types specially designed for the long runs of the Union Limited and Union Express passenger trains between Cape Town and Johannesburg, were delivered in 1925.

Characteristics

These locomotives conformed to SAR requirements as far as practicable, but also incorporated the latest American railway engineering practices. They introduced several features which were new to the SAR at the time, such as top feeds to the boiler, self-cleaning smokeboxes, Sellar's drifting valves and grease lubrication to the coupled wheel axleboxes, crank pins and connecting rod big ends. Their fireboxes were equipped with flexible side stays and water siphon arch tubes to support the brick arch and to improve circulation. Their Type KT tenders, arranged with self-trimming type coal bunkers, had a coal capacity of 14 long tons (14.2 tonnes) and a water capacity of , which was considered sufficient for the engines to travel 100 miles (161 kilometres) without having to replenish water.

The locomotives represented a considerable advance in power over the Classes 15, 15A and 15B. They had 5 inches (127 millimetres) thick bar frames and their boilers were larger in proportions than that of any existing SAR locomotive, while their boiler pitch was raised higher than that of anything else in service at that time. The boilers were equipped with three Coale pop type safety valves and a Schmidt type superheater. To reduce the length between boiler tube plates, a 2 feet 3 inches (686 millimetres) long combustion chamber was provided in the firebox. The locomotive's size quickly earned it the nickname Big Bill, while its contemporary Class 16D 4-6-2 Pacific type, which arrived from the same builders in the same shipment, was nicknamed Big Bertha.

The first two locomotives, designated Class 15C with engine numbers 2060 and 2061, were erected at the Salt River shops and put to work on the line from Cape Town to Touws River. They performed well, were comparatively trouble-free, and were good steamers, capable of handling a heavy load exceeding that of any other locomotive which had been employed on this section to date.

Because of the good results obtained from these two engines, an order was placed with Baldwin for another ten locomotives, which were delivered in 1926, numbered in the range from 2062 to 2071. All these locomotives were delivered new with copper fireboxes, but once sufficient water treatment facilities were available to prevent problems with corrosion, these were gradually replaced with steel fireboxes as and when firebox replacement became necessary.

Reclassification

Shortly after being placed in service, the Class 15C's frames began to show evidence of cracking. A similar locomotive, which differed mainly in the design of the frame under the firebox, was then ordered from the American Locomotive Company (ALCO). When the 23 ALCO-built locomotives were placed in service in 1926, they were designated Class 15CA, with the "A" supposedly indicating the manufacturer ALCO rather than, as was usual SAR practice, a different version of an existing locomotive type.

The Class 15C was then, rather unnecessarily, reclassified to Class 15CB, with the "B" merely to indicate the manufacturer Baldwin and not, as was usual practice, a branchline locomotive.

Modifications

Retyring

They were delivered with coupled wheels and their boiler safety valves were set at an operating pressure of . All twelve engines eventually had their coupled wheels retyred to diameter and, to compensate for the loss of tractive effort due to the larger diameter wheels, their operating boiler pressure was increased to by an adjustment of the setting of their safety valves. This modification enabled these mixed traffic locomotives to handle the fastest mainline passenger trains. Probably at the same time, their cylinders were reamed from a 23 to 24 inches (584 to 610 millimetres) bore.

When larger tyres were fitted, the old tyres were left in position and turned down on the wheel centres to serve as liners, and the new tyres were then shrunk on over the liners. The practice of increasing the diameter of coupled wheels, wheel spacing and other considerations permitting, was begun by A.G. Watson during his term in office as Chief Mechanical Engineer (CME) and was continued by his successors. The reduction of tractive effort caused by the larger wheels, was made up by increasing boiler pressures or by fitting larger cylinders or both, as required. This policy resulted in more mileage between heavy repairs, less cost-per-mile on repairs and locomotives capable of higher speeds.

Reboilering

Three of the Class 15CB and Class 15CA locomotives were reboilered during the early 1940s, with new boiler numbers in the range from 9504 to 9506. These boilers were of similar dimensions to the originals, but with a different tube arrangement, and were designed by Dr. M.M. Loubser, CME at the time. The reboilered locomotives were not reclassified.

Service

South African Railways

The locomotives gave good service and were justifiably popular with traffic, running and engineering staff alike. The introduction of these large engines, along with their Class 16D 4-6-2 Pacific type Big Bertha siblings, resulted in a complete revision of traffic operation between Cape Town and Johannesburg. The Pacifics were scheduled to work the 616 miles (991 kilometres) stretch between Johannesburg and Beaufort West, while the Big Bill Mountains entered service on the 340 miles (547 kilometres) stretch from Beaufort West to Cape Town, with its ruling gradient of 1 in 40 (2½%) and severe curvature for approximately 22 miles (35 kilometres) on the Hex River Pass section between Touws River and De Doorns.

They were later transferred to Bloemfontein, from where they worked south to Noupoort. A brief stint on the Natal north coast followed in the mid-1960s, after which they spent the rest of their SAR working lives in the Eastern and Western Transvaal. They were withdrawn from SAR service in 1976.

Industrial

Eleven Class 15CB locomotives were sold into industrial service in 1976, with only the first-built, no. 2060, being retained by the SAR for preservation. By the late 1980s, therefore, at more than 60 years of age, eleven of the original twelve Class 15CB locomotives were still at work.

• Numbers 2061, 2065 and 2070 became South Witbank Coal Mine's numbers 3, 2 and 1 respectively.
• Numbers 2062 and 2067 went to Tweefontein United Collieries.
• Numbers 2063 and 2064 went to Dunn's Locomotive Works to be employed at Durban Navigation Collieries (Durnacol) in Natal. No. 2063 was subsequently resold to Rustenburg Platinum Mines, becoming their no. 5, and no. 2064 was resold to Tavistock Colliery, becoming their no. 3.
• Numbers 2066 and 2068 went to Tavistock Colliery, becoming their numbers 4 and 5 respectively.
• Numbers 2069 and 2071 went to Rustenburg Platinum Mines, becoming their numbers 3 and 4 respectively.

Illustration

The main picture shows a Class 15C, as delivered, c. 1925, while the following show two Class 15CB locomotives in industrial service after withdrawal from SAR service.

• SAR Class 15CB No.4 (Ex SAR 2071) Rustenburg Platinum Mines 310383.jpg

  No. 2071 as Rusplats no. 4, Rustenburg, 31 March 1983

• SAR Class 15CB 2064 (SAR 15CB) Durban Navigation Dannhauser 110479.jpg

  No. 2064 at Durnacol, Dannhauser, Natal, 11 April 1979